This standard is issued under the fixed designation F3140; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.

1. Scope

1.1

This test method covers a procedure for the fatigue testing of metallic tibial trays used in partial knee joint replacements.

1.2

This test method covers the procedures for the perfor-mance of fatigue tests on metallic tibial components using a cyclic, constant-amplitude force. It applies to tibial trays which cover either the medial or the lateral plateau of the tibia.

1.3

This test method may require modifications to accom-modate other tibial tray designs.

1.4

This test method is intended to provide useful, consistent, and reproducible information about the fatigue performance of metallic tibial trays with unsupported mid-section of the condyle.

1.5

The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appro-priate safety, health, and environmental practices and deter-mine the applicability of regulatory limitations prior to use.

1.7

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

2. Referenced Documents

2.1 ASTM Standards:2

3. Terminology

3.1 Definitions:

3.2 Definitions of Terms Specific to This Standard:

4. Significance and Use

4.1

4.2

4.3

5. Specimen Selection

5.1

6. Apparatus

6.1

6.2

6.3

6.4

6.5

6.6

7. Equipment Characteristics

7.1

7.2

7.3

8. Procedure

8.1

8.2

8.3

8.4

8.5

8.6

8.7 Test Frequency

8.8 R value

8.9

8.10

9. Test Termination

9.1

10. Report

10.1

10.2

10.3

10.4

11. Precision and Bias

11.1 Precision

11.2 Bias

12. Keywords

12.1

REFERENCES

ASTM F3140 - 23

Standard Test Method for Cyclic Fatigue Testing of Metal Tibial Tray Components of Unicondylar Knee Joint Replacements

Current

Published:

1 Sep 2023