BS EN IEC 60034-18-32 discusses rotating electrical machines and functional evaluation of insulation systems with a focus on electrical endurance qualification procedures for form-wound windings.
BS EN IEC 60034-18-32 is the eighteenth part of the BS EN IEC 60034 series that describes qualification procedures for the evaluation of electrical endurance of insulation systems for use in rotating electrical machines using form-wound windings energized with sinusoidal power frequency voltage.
The test procedures for the main wall insulation are comparative in nature, such that the performance of a candidate insulation system is compared to that of a reference insulation system with proven service experience.
The qualification procedures of the inverter duty insulation system for form-wound windings can be found in IEC 60034-18-42 or IEC 60034-18-41. A new and informative test procedure for the stress control system is introduced and defined in BS EN IEC 60034-18-32.
BS EN IEC 60034-18-32 on electrical endurance qualification procedures for form-wound windings is useful for:
Electrical ageing tests are usually performed at fixed voltage levels until failure (main wall insulation) or in combination with elevated temperature until signs of deterioration occur (Conductive slot coating system).
BS EN IEC 60034-18-32 deals exclusively with insulation systems for form-wound windings (Type II) and concentrates on electrical functional evaluation.
BS EN IEC 60034-18-32 primary aim is to establish the lifetime curve of the main wall insulation from which the expected lives may be estimated. The second aim is to establish that the conductive slot coating and the stress control coating are suitable for service.
BS EN IEC 60034-18-32 provides you with guidance on the selection and designation of test procedures, full evaluation of the main wall insulation, evaluation of the stress control system, test objects, electrical ageing, diagnostic sub-cycle, failures of the main wall insulation functional evaluation of the main wall data, etc.
With obedience and compliance to BS EN IEC 60034-18-32, you can enhance form-wound windings’ effectiveness and efficacy and manufacture a standardized product.
A Commented Version (CMV) of this standard is available here. Please note, the CMV of the standard is not adopted, and therefore doesn’t contain an additional national foreword, or national annex that might be contained in the BS adoption of the standard. However the IEC text that forms the content of the standard is identical to the BS adoption of the standard.
Commented Versions (CMVs) are specialized publications featuring detailed commentary from technical experts on the major changes between the new edition of a standard and the previous one. Comments may include an explanation for the changes as well as information on the impact of these changes on the application and usability of the standard.
IEC 60034-18-32 Ed.2.0
EN 60034-18-32 Ed.2.0