ISO 12614‑11 is the part 11 of the multi series standard that specifies tests and requirements for the fittings, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833.
ISO 12614‑11 is based upon a working pressure for natural gas as a fuel of 1,6 MPa [16 bar1)]. Other working pressures can be accommodated by adjusting the pressure by the appropriate factor (ratio). For example, 2 MPa (20 bar) working pressure system will require pressures to be multiplied by 1,25.
NOTE-
ISO 12614‑11 is not applicable to the following:
ISO 12614‑11 on fittings for liquefied natural gas (LNG) fuel system components is applicable to:
Good quality fuel system components are very important for the efficient functioning of an LNG vehicle. ISO 12614‑11 gives you guidelines for the construction and assembly of fittings. This will help you manufacture better quality fittings
ISO 12614‑11 provides tests to check the hydraulic strength and bending tolerance of the fittings. When performed these tests will help you in measuring the strength of the fittings.
ISO 12614‑11 provides marking instructions on fittings, these markings will help in identifying and tracing fittings.
BS ISO 12614‑11:2021 edition cancels and replaces the first edition (ISO 1261411:2014), which has been technically revised.
The main changes compared to the previous edition are as follows:
ISO 12614-11