BS EN 50355 is a European standard that discusses railway rolling stock cables having special fire performance. BS EN 50355 outlines guidance on the safe use of rolling stock cables specified in EN 50264, EN 50306 and EN 50382 to ensure essential safety is achieved.
These cables can only be used for the wiring of railway rolling stock and within the limits given in the manner described in BS EN 50355. All these cables are for fixed installation where there is no free movement of the cable, except for stresses due to typical service.
BS EN 50355 is applied in conjunction with the relevant product and installation standards. Stricter requirements than those given in this standard could be necessary.
Note 1: Legal or statutory requirements do take precedence over the guidance given in BS EN 50355.
Note 2: BS EN 50355 does not apply to:
Note 3: In cases where no guidance exists or where it cannot be derived from general information, it is recommended that advice be sought from the cable manufacturer.
BS EN 50355 on guide to using railway rolling stock cables is useful for:
Railway rolling stock cables are intended for the transmission and distribution of electricity in monitoring, control, and power circuits.
BS EN 50355 guideline assists you with the requirements for safety, fire, limiting conditions, cable designation, initial inspections, periodic inspections, and electrical tests after installation for railway rolling stock cables.
With obedience and compliance to BS EN 50355, you can standardise the performance of railway rolling stock cables and minimise the hazard to people when a fire may damage the cable.
EN 50355:2013