Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

International Standards are drafted according to the rules given in the ISO/IEC Directives, Part 2.

The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.

Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights.

ISO 3547‑6 was prepared by Technical Committee ISO/TC 123, Plain bearings, Subcommittee SC 5, Quality analysis and assurance.

This part of ISO 3547 cancels and replaces ISO 12307‑2:2000, which has been technically revised.

ISO 3547 consists of the following parts, under the general title Plain bearings — Wrapped bushes:

— Part 1: Dimensions
— Part 2: Test data for outside and inside diameters
— Part 3: Lubrication holes, grooves and indentations
— Part 4: Materials
— Part 5: Checking the outside diameter
— Part 6: Checking the inside diameter
— Part 7: Measurement of wall thickness of thin-walled bushes

BS ISO 3547-6:2007

Plain bearings. Wrapped bushes - Checking the inside diameter

Published:

30 Nov 2007

Withdrawn:

12 May 2020