BS EN 61300-3-39 discusses fibre optic interconnecting devices and passive components and basic test and measurement procedures with a focus on examinations and measurements and physical contact (PC) optical connector reference plug selection for return loss measurements. Fibre optic interconnecting devices and passive components do not require electrical-to-optical or optical-to-electrical conversion during their operation.
BS EN 61300-3-39 provides the objective that is to select non-angled physical contact (PC) optical connector plugs for use as the reference plug in the return loss RL measurement and to define an acceptance return loss value RLa for use in plug acceptance testing.
BS EN 61300-3-39 describes the procedure that is for use to guarantee a certain return loss value RL when two plugs have been successfully tested against the reference connector when randomly mated.
BS EN 61300-3-39 on fibre optic interconnecting devices and passive components is useful for:
Fibre optic interconnecting devices and passive components are widely used by people as a promising solution for modern access to telecommunication networks. The measurement set-up for return loss measurements is designed on the basis of the method used for the measurement of connector return loss.
BS EN 61300-3-39 provides guidance on reference plug selection, and measurement of minimum acceptable RL of a plug under test and accuracy considerations.
BS EN 61300-3-39 describes the procedure required to measure the optical connector reference plug selection for return loss measurements.
BS EN 61300-3-39 helps you improve the quality of fibre optic interconnecting devices and passive components.
EN 61300-3-39:2012
IEC 61300-3-39:2011