Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the different types of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).

Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents).

Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement.

For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISO's adherence to the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see www.iso.org/iso/foreword.html.

This document was prepared by Technical Committee ISO/TC 83, Sports and other recreational facilities and equipment, Subcommittee SC 4, Snowsports equipment.

This fifth edition cancels and replaces the fourth edition (ISO 9462:2014), which has been technically revised.

The main changes are as follows:

— modification of definitions and addition of notes to entry in 3.1.1, 3.1.2 and 3.1.3;
— addition of 3.1.4;
— addition of new Figure 2 “Application of F_y,toe and F_z,heel”;
— modification of 4.3;
— addition of new 6.8 “Compatibility to boot in accordance with ISO 23223”;
— addition of new Figure 8 “Clearance area around the antifriction device (AFD)”;
— addition of new Table 4 “Compatibility marking”;
— correction of scale of Figure D.2 “Tolerances on M_y”;
— addition of new Annex E “Test body in accordance with ISO 9838 for compatibility test”.

Any feedback or questions on this document should be directed to the user’s national standards body. A complete listing of these bodies can be found at www.iso.org/members.html.

BS ISO 9462:2023

Alpine ski-bindings. Requirements and test methods

Current

Published:

28 Feb 2023